Connector Pinouts For An Mx Series Cb-Re Or Rcb Management Port - Juniper MX10003 Hardware Manual

Table 32: RJ-45 Connector Pinout for the AUX and CONSOLE Ports
Pin Signal
1 RTS
2 DTR
3 TXD
4 Ground
5 Ground
6 RXD
7 DSR/DCD
8 CTS
RJ-45 Connector Pinouts for an MX Series CB-RE or RCB Management
Port
The port on the Control Board and Routing Engine (CB-RE; Routing and Control Board (RCB)) labeled
MGMT is an autosensing 10/100/1000-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable
for connecting the Routing Engine to a management LAN (or other device that supports out-of-band
management).
NOTE: In routers where the Routing Engine and Control Board (CB) are integrated into a single
board, a CB-RE is known as Routing and Control Board (RCB). The RCB is a single FRU that
provides Routing Engine and CB functionality.
Table 33 on page 80 describes the RJ-45 connector pinout.
Table 33: RJ-45 Management Port Connector Pinouts for the CB-RE or RCB MGMT Port
Pin
1
Description
Request to Send
Data Terminal Ready
Transmit Data
Signal Ground
Signal Ground
Receive Data
Data Set Ready
Clear to Send
Signal
TRP1+
Description
Transmit/receive data pair 1
80