Mx960 Router Grounding Cable Specifications; Rj-45 Connector Pinouts For An Mx Series Routing Engine Ethernet Port - Juniper MX960 Hardware Manual

Figure 51: Grounding Cable Lug
End view
0.28
diameter
0.55
each hole
0.08 0.25 0.625

MX960 Router Grounding Cable Specifications

The 48 VDC facility must be equipped with a circuit breaker rated 40 A (–48 VDC), or 60 A (–48 VDC),
and the grounding cable must be minimum 10 AWG, or as required by the local code.
NOTE: Additional grounding is provided to an AC-powered router when you plug its power
supplies into grounded AC power receptacles.
WARNING:
protective earthing terminal (Metric [–M6] and English [–¼-20] screw ground lugs)
provided on the chassis in addition to the grounding pin of the power supply cord. This
separate protective earth terminal must be permanently connected to earth.
RELATED DOCUMENTATION
Grounding the MX960 Router | 334
Tools and Parts Required for MX960 Router Grounding and Power Connections | 333

RJ-45 Connector Pinouts for an MX Series Routing Engine ETHERNET Port

The port on the Routing Engine labeled ETHERNET is an autosensing 10/100-Mbps Ethernet RJ-45
receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or
other device that supports out-of-band management).
pinout.
2.25
Crimp area
All measurements in inches
0.37
The router is installed in a restricted-access location. It has a separate
6 AWG conductor
Table 84 on page 201 describes the RJ-45 connector
200