Table 40: Rj-45 Connector Pinout; Table 41: Db-9 Connector Pinout; Rj-45 Connector Pinouts For The Tx Matrix Management Ethernet Port; Console Ports - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide

RJ-45 Connector Pinouts for the TX Matrix Management ETHERNET Port

Related
Documentation
DB-9 Connector Pinouts for the TX Matrix Management AUXILIARY and CONSOLE
Ports
346
The port on the TX-CIP labeled
RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a
management LAN (or other device that supports out-of-band management). Table 40
on page 346 describes the RJ-45 connector pinout.

Table 40: RJ-45 Connector Pinout

Pin Signal
1 TX+
2 TX –
3 RX+
4 Termination network
5 Termination network
6 RX–
7 Termination network
8 Termination network
TX Matrix Connector Interface Panel (TX-CIP) Overview on page 38
TX Matrix Management Port Cable Specifications on page 345
The ports on the TX-CIP labeled
accept RS-232 (EIA-232) cable. The
laptop, modem, or other auxiliary unit, and the
management console. The ports are configured as data terminal equipment (DTE). Table
41 on page 346 describes the DB-9 connector pinouts.

Table 41: DB-9 Connector Pinout

Pin Signal
1 DCD
2 RxD
3 TxD
is an autosensing 10/100-Mbps Ethernet
ETHERNET
AUXILIARY and CONSOLE
port connects the Routing Engine to a
AUXILIARY
port connects it to a
CONSOLE
Direction Description
<– Carrier Detect
<– Receive Data
–> Transmit Data
Copyright © 2010, Juniper Networks, Inc.
are DB-9 receptacles that