Basic Connection And Configuration With The J-Web Interface; Step 1. Connecting, Logging In, And Starting The J-Web Interface - Juniper JUNOS J Series Quick Start Manual

3.
4.
For complete instructions, see the JUNOS Enhanced Services J-series Services Router
Getting Started Guide.

Basic Connection and Configuration with the J-Web Interface

For J-Web access, you connect from your management PC or laptop to the Services
Router through one of the built-in Ethernet interfaces. The examples in this document
use port 0/0. (For information about the J-Web interface, see J-Web
Basics" on page 15.)

Step 1. Connecting, Logging In, and Starting the J-Web Interface

When the Services Router is powered on for the first time, it searches for a DHCP
server, and if it does not find one, it assigns an IP address within the
subnetwork to any devices connected to it.
To connect to the J-Web interface through port
1.
2.
3.
4.
If the power supply includes a on/off switch, turn the switch to on.
c.
For a DC power supply only:
Ensure that the voltage across the DC power source cable leads is 0 volts
a.
and that the cable leads cannot become active during installation.
Remove the clear plastic cover protecting the terminal block.
b.
c. Remove the two center screws next to the labels
Secure the positive (
d. +
tightening the screw only until snug. Do not overtighten.
Secure the negative (–) DC source power cable lug to the
e.
tightening the screw only until snug. Do not overtighten.
Replace the plastic cover.
f.
Repeat Step 2 or Step 3 for the second power supply, if one is installed.
On the management device, such as a PC or laptop, you use to access the J-Web
interface, verify that the address of the port that you connect to the router is set
to one of the following:
An Ethernet address on the
192.168.1.1
An Ethernet address from a DHCP server
Turn off the power to the management device.
Plug one end of the Ethernet cable into the Ethernet port on the management
device.
Connect the other end of the Ethernet cable to the built-in Ethernet port on the
router.
Basic Connection and Configuration with the J-Web Interface
Basic Connection and Configuration with the J-Web Interface
) DC source power cable lug to the
on the router:
0/0
subnetwork other than
192.168.1/24
–48 VDC and RTN .
terminal,
RTN
terminal,
–48 VDC
192.168.1.0/24
9