Encapsulation Capabilities - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Encapsulation Capabilities

504
the physical interface, VLAN IDs from 1 through 511 are no longer reserved for normal
VLANs.
PPP—Defined in RFC 1661, The Point-to-Point Protocol (PPP) for the Transmission of
Multiprotocol Datagrams over Point-to-Point Links. PPP is the default encapsulation
type for physical interfaces. E1, E3, SONET/SDH, T1, and T3 interfaces can use PPP
encapsulation.
NOTE: When the encapsulation type is set to Cisco-compatible Frame Relay
encapsulation, ensure that the LMI type is set to ANSI or Q933-A.
In ACX Series routers, VPLS is supported only on ACX5048 and ACX5096
routers.
When you configure a point-to-point encapsulation (such as PPP or Cisco HDLC) on a
physical interface, the physical interface can have only one logical interface (that is, only
one statement) associated with it. When you configure a multipoint encapsulation
unit
(such as Frame Relay), the physical interface can have multiple logical units, and the
units can be either point-to-point or multipoint.
Ethernet CCC encapsulation for Ethernet interfaces with standard TPID tagging requires
that the physical interface have only a single logical interface. Ethernet interfaces in VLAN
mode can have multiple logical interfaces.
For Ethernet interfaces in VLAN mode, VLAN IDs are applicable as follows:
VLAN ID 0 is reserved for tagging the priority of frames.
For encapsulation type vlan-ccc
VLAN IDs 512 and above are reserved for VLAN CCCs.
When you configure Ethernet virtual LAN (VLAN) encapsulation on CCC circuits (by
using the
encapsulation vlan-ccc
hierarchy level), you can bind a list of VLAN IDs to the interface by using the
statement to configure a CCC for multiple VLANs. Configuring this
[ vlan-id-numbers ]
statement creates a CCC for:
Each VLAN listed—for example,
Each VLAN in a range—for example,
Each VLAN in a list and range combination—for example,
300 ]
For encapsulation type
vlan-vpls
and VLAN IDs 512 through 4094 are reserved for VPLS VLANs. For 4-port Fast Ethernet
interfaces, you can use VLAN IDs 512 through 1024 for VPLS VLANs.
For Gigabit Ethernet interfaces and Gigabit Ethernet IQ and IQE PICs with SFPs (except
the 10-port Gigabit Ethernet PIC and the built-in Gigabit Ethernet port on the M7i router),
, VLAN IDs 1 through 511 are reserved for normal VLANs.
statement at the
[edit interfaces interface-name]
vlan-id-list [ 100 200 300 ]
vlan-id-list [ 100-200 ]
, VLAN IDs 1 through 511 are reserved for normal VLANs,
Copyright © 2017, Juniper Networks, Inc.
vlan-id-list
vlan-id-list [ 50, 100-200,