Honda Prelude 1993 Service Manual page 1362

Hide thumbs Also See for Prelude 1993:

Table of Contents

Cruise Gontrol

Actuator/Cable Replacement

Pull the boot back and loosen the locknut. then

disconnect the cable from the bracket.

Disconnect the cable end from the actuator rod.

Disconnect the 4-P connector trom the actuator.

Pull the vent hose out of its grommet.

Remove the two mounting bolts and the actuator

with the bracket.

Disconnect the vacuum hose from the check valve.

lf necessary, disconnect the cable end from the

linkage over the accelerator pedal, then turn the

grommet 9Oo in the bulkhead and remove the

Install in the reverse order of removal, and adjust

tree play at the actuator rod after connecting the

cable (see next column),

Actuator Cable Adjustment

Check that the actuator cable operates smoothly

with no binding or sticking.

Start the engine.

Measure the amount of movement of the actuator

rod until the cable pulls on the accelerator lever

(engine speed starts to increase). Free play should

b e 1 1 t 1 . 5 m m ( O . 4 3 t 0 . 0 6 i n ) .

LOCKNUT FREE PLAY: 11 a 1.5 mm

(0.43 r 0.06 inl

lf Jree play is not within specs, loosen the locknut

and turn the adjusting nut as required.

NOTE: lf necessary. check the throttle cable free

play {see section 11), then recheck the actuator

rod free play.

Retighten the locknut and recheck the free play.

ACTUATOR ROD

Troubleshooting