Clutch Switch Test
1. Disconnect the 3-P connector from the clutch
switch.
2. Check for continuity between the terminals accor-
ding to the table.
lf necessary, replace the switch or adjust pedal
height (see section 12).
A/T Gear Position Switch Test
1. Remove the tront console, then disconnect the
12-P connector from the switch.
2, Check tor continuity between the terminals in each
switch position according to the table.
3,
lI necessary, replace the switch {see page 23-149).
\
Terminal
'c*.hP;f-l
B
PUSHED
BELEASED
o-
o
Terminal
Position
5
8
tr
o-
------o
tr
o_- ------o
E
o
--o
N
tr
E
23-281