Honda Prelude 1993 Service Manual page 1232

Safety Indicator
Indicator Input Test
2 .
a All SRS eloclricsl widng ha]nosses are coverod with
yollow out€r insulation.
a Bofole disconnecting the SRS wira ham€ss, install
ths short connoctor(s) on the airbag(s) lsee page
23-294t.
a Replaco the sntir€ affectad SRS harness assembly il
it has an opon circuit or damagod wiring.
a Aftor installing th6 gaug€ a$ombly, lochock ths
operation of the SRS indicator light.
1. Remove the sub gauge assembly from the dash-
board (see page 23-130).
Disconnect the 30-P connector from the sub gauge
assembly.
Inspect the connector and socket terminals to be
sure they are all making good contact.
a lf the terminals are bent, loose, or corroded,
repair them as necessary, and recheck the
sysrem.
a lf the terminals look OK. make the following in-
put tests at the connector.
- It a test indicates a problem, find and correct
the cause, then recheck the system.
- lf allthe input tests prove OK, the printed cir-
cuit board must be faulty; replace it.
SUB GAUGE ASSEMBLY
Viow lrom wire side
GRN/BED
23-154
I
I