Honda Prelude 1993 Service Manual page 1390

Hide thumbs Also See for Prelude 1993:

Table of Contents

Mode F: Open in lront passongot's airbag inflatol'

NOTE: The rsdio may have a s-digit coded theft pro-

tection circuit. Bs sure to get the customer's code

number before disconnecting the battery cables.

1. Belore disconnecting any part of the SRS wire

harness, installthe short connector(s) (RED) on the

airbag(s) (see page 23-2941'

2. Connect Test Harness B (o7MAz-SPoOsoo) be-

tween the SRS unit and SRS main harness 18-P

Reconnect the front passenger's ai.bag connector,

then measure the resistance between the 82 ter-

minal and 88 terminsl.

TEST HABI{ESS B

oTMAZ - SPOO5d'

It resistance is more than O.2 K0, go to step 4.

ll resistance is less than O 2 KO, the SRS unit is

faulty. Substitute a known-good SRS unit and

recheck the voltages according to the chart on

page 23-305.

Disconnect the front passenger's airbag 3-P con-

nsctor from the SRS main harness, then connect

Test Harness C (O7LAZ-S14030O) to the tront

passenger's airbag side of the connector.

PASSENGER'S AIRBAG

TEST HARNESS C

07LAZ-S140300

Measure the resistance between the No. 7 terminal

and the No. 8 terminal.

TEST HABNESS C

07LAz - S[/rO3o,0

lf resistance is more than O.2 K0, the front

passenger's airbag inflator is faulty. Replace the

front passenger's airbag assembly and recheck

the voltages according to the chart on page

lf resistance is less than O.2 KO, the cable reel is

taultv. Replace the cable reel and recheck the

voltages according to the chart on page 23-305.

Troubleshooting