Honda Prelude 1993 Service Manual page 1373

Hide thumbs Also See for Prelude 1993:

Table of Contents

Supplemental Restraint System (SRS)

Steering-related Precautions

Steering Wheel and Cable Reel Alignment

NOTE: To avoid misalignment of the steering wheel or

airbag on reassembly, make sure the wheels are turned

straight ahead betore removing the steering wheel.

Rotate the cable reel clockwise until it stops.

Then rotate it counterclockwise (approximately two

turns) until:

- The yellow gear tooth lines up with the alignment

mark on the cover.

- The arrow mark on the cable reellabelpoints straight

Steering Column Removal

a Eefors romoving the steering column, fitst discon-

noct the conn€ctor betwoen th€ cable reol and the

SRS main harn€ss.

a It tho steeling column is going to bo removed

withoul dismounting the ste€ring wheel. lock ths

stesring by turning tho ignition key to O-LOCK posi-

tion 01 rsmova the key from ths ignition so that the

staering wh6al will not turn,

Do not replace the original steering wheel with any

other design, since it will m8ke it impossible to pro-

perly install the ai.bag (only use genuine Honda

replacement partsl.

After reassembly confirm that the wheels are still

turned straight ahead and that the steering wheel

spoke angle is correct. lf mino. spoke angle adjust-

ment is necsssary, do so only by adjustment of the

tie-rods, not by removing and repositioning the

stee.ing wheel.

NOTE: Models with 4WS

Test and adiust the 4WS system (see section 17).

Troubleshooting