Honda Prelude 1993 Service Manual page 1273

Brake Switch
Test
1 .
2 .
lf one of the brake lights does not go on. check the
bulb in the taillight or the high mount brake light.
lf none of the brake lights go on, check the No. 41
(1 5 A) fuse in the under-hood tuse/relay box.
lf the tuse and bulbs are OK, disconnect the 4-P
connector from the brake switch.
4-P CONNECTOR
Check for continuity between the B and C ter-
minals. There should be continuitv with th€ brake
pedal pushed.
a lf there is no continuity, adjust the pedal height
(see section 19), and recheck.
a It there is still no continuity, replsce the switch.
a lf there is continuity, but the brake lights do not
go on, check for:
P o o r g r o u n d ( G 5 5 1 ) .
- An ooen in the WHT/YEL or GRN/WHT wire.
- Faulty brake light failure sensors (see page
2 3 - 1 5 7 t .
A B
il+
"JE={"
High Mount Brake Light/Bulb
1 .
Inspect the bulbs and replace them if they are burn-
ed out.
\,
2
4 .
Replacement
Remove the cover.
ll the light is taulty, remove its two mounting bolts.
Disconnect the 3-P connector and remove the light.
NOTE: Clean the rear window glass first. and
make sure the rubber seal on the light is touching
the glass all the way around.
l i
COVER
HtGH ttiouNT BRAKE LrcHT
lnstall in the reverse order of removal,
23-1
95