Honda Prelude 1993 Service Manual page 1408

CAUTION: Ba sur€ to install tho SRS widng so that
it is not pinch6d 01 intorfefng with othor cal pada'
lnstall the new SBS unit.
sns uNlr
ToRxo BOLTS 6 mm
10 N.m tl.O kg-m,7.2 lb-ft)
ReDlace.
U3e a TORxo T3O bit
SRS MAIN
HARNESS
18.P CONNECTOR
TORXo SOLTS 6 mm
1O N'm 11 0 kg-m' 7.2 lb-ft|
RePlace.
Ut. a TORXo T30 blt
Connect the SRS main harness 18-P connector to
the SRS unit; push it into position until it clicks.
Install the SRS unit covers (right and lett).
8 .
\
1 0 .
Remove and properly store the short connector{sl
{RED), then reconnect the airbag connector(s} (and
reinstall the glove box).
Reconnect the battety positive cable, then the
negative cable,
After installing the SRS unit. confirm proper
system operation: Turn the ignition to ll; the instru-
ment panel SRS indicator light should go on for
about six seconds and then go otf
Enter the code number to restore radio operation
(see page 23-206).
1 1 .
' 1 2 .
23-331