Honda Prelude 1993 Service Manual page 1325

2 .
Power Mirror Motor Test
1. C8r€fully pry out the window corneJ panel with a
flat tip screwdriver.
Remove the door panel.
Disconnect the 3-P or 6-P connector from the
mirrot.
Power Mirror Replacement
NOTE: Be{ore removing the mirror, lower the window
tully.
1. Carefully pry out the window corner panel with a
flat tip screwdriver.
2.
Remove the door Panel.
3.
Disconnect the 3-P or 6-P conn€ctor from the
mirlor.
4. While holding the mirror with one hand, remove the
three mounting screws with the other.
@-
3-P CONNECTOR 6-P CONI{ECTOR
tusAl
(Canadal
4. Test actuato. operation:
5. Check tor continuity between the No. 1 and No. 2
terminals {RX 103 scale).
There should be continuity.
TILT UP
Connect batterv power to the No.
3 terminal and ground to the No.
4 terminal.
TILT DOWN
Connect battery powel to the No.
4 terminal and ground to the No.
3 terminal.
SWING LEFT
Connect batterv power to the No,
4 terminal and ground to the No.
5 terminal.
SWING
RIGHT
Connect battery Power to the No.
5 terminal and ground to the No.
4 terminal.
23-247