Honda Prelude 1993 Service Manual page 1224

A/T Gear Position lndicator
Indicator Input Test
CAUTION:
a All SRS €lectrical wiring harnosses a.e coveled with
y€llow outor insulation.
a Betoro disconn€cting the SRS wirs harnoss, install
the shon connectorls) on the airbag{s} {see page
23-294t.
a Feplace tho entire atfoctod SRS hamoss assembly if
it has an open circuit or damag€d wiring.
a After installing the gauge ssssmbly, r6check tho
operation of tho SRS indicatol light.
1. Remove the main gauge assembly from the dash-
b o a r d { s e e p a g e 2 3 - 1 3 O ) .
2, Disconnect the 16-P and 1O-P connectors from it.
3.
Inspect the connector and socket terminals to be
sure they are all making good contact.
a lf the terminals afe bent, loose, o. corroded,
repair them as necessary, and recheck the
sysrem.
a lf the terminals look OK, make the loltowing in-
put tests at the connector.
- lf a test indicates a problem, find and correct
the cause, then recheck the system.
- lf all the input tests prove OK, the indicator
must be faulty; replace the gauge assembly.
NOTE: Different wires with the same color have
been given a number suflix to distingujsh them
{YELj and YEL2 are not the same).
View from wire side
SRS MAIN HARNESS
23-146