Honda Prelude 1993 Service Manual page 1371

Hide thumbs Also See for Prelude 1993:

Table of Contents

Supplemental Restraint System (SRS)

Wiring Precautions

a Never attempt to modity. splice or repair SRS wiring.

NOTE: SRS wiring can be identified by special

yellow outer protective covering.

Be sure to install the harness wires so that they are

not pinched o. interfering with other car parts.

Make sure all SRS ground locations are clean and

grounds are securely fastened for optimum metal-to-

metal contact. Poor grounding can cause intermit-

tent problems that are difficult to diagnose.

Instslling the short connector

To avoid accidenrat deployment 8nd

possible injury. always install ths protective short con-

nector(s) on the driver's and passonget's airbag con-

nector(s) belore working noar any SRS wiring.

NOTE: The radio may have a s-digit coded theft pro-

tection circuit. Be sure to get the customer's code

number befo.e disconnecting the battery.

Disconnect the battery negative cable, then

disconnect the positive cable.

Install the short connector{s)(RED):

Driver's Sido:

a Remove the access panel from the steering wheel,

then remove the short connector (REDI from the

Disconnect the 3-P connector between the driver's

airbag and cable reel, then lnstallthe short connector

(RED) on the airbag side of the connector.

Troubleshooting