Honda Prelude 1993 Service Manual page 1404

1 7 . Install the steering wheel nut.
NOTE: Models with 4WS
Check that the 4WS system is neutral (see section
STEERING WHEEL NUT
50 N.m (5 kg-m, 36 lb-It)
TORXO BOLTS
10 N'm (1.0 kg-m. 7.2 lb-ft)
BeDlace.
U3o a TORXo T30 blt
18. Install the driver's airbag assembly'
19. Connect the cable reel 6-P connector to the SRS
main harness, then installthe air duct, knee bolster'
and dashboard lower cover.
1 7 ) .
DASHBOARD LOWER COVER
\
20. Remove and properly store the short connector(s)
{RED), then reconnect the airbag connector(s} {and
reinstall the glove box).
2'1. Reconnect the battery positive cable, then the
negative cable,
22. Atter installing the cable re€|, conJirm proper
system operation:
a Turn the ignition ON (ll); the instrument panel
SRS indicator light should go on for about six
seconds and then go otf
a Make sure both horn buttons work.
a Make sure the headlight and wiper switches
work,
a Go for a test drive and make sure the cruise con-
trol set/resume switch work.
a Rotate the steering wheel counterclockwise to
make sure the yellow gear tooth lines up with
the slot on the cover.
YELLOW GEAR TOOTH
23. Enter the code number to resto.e radio operation
(see page 23-206).
23-327