Honda Prelude 1993 Service Manual page 1291

Power Antenna Motor Test
.
Remove the trunk right side trim panel.
l.
Disconnect the 3-P connector from the motor. and
remove the connector from its clamp.
3.
First, check power to the motor at the connector
termrnals:
a There should be battery voltage between the
WHT/YEL (+) and BLK {-) terminals allthe time
a There should be battery voltage between the
YEL/WHT (+) and BLK {-) terminals only with
the ignition and radio switched ON.
View from wire side
View from wire side
Tesl motor operation:
EXTEND: Connect battery power to the No. I and
No. 2 terminals and ground to the No. 3
terminal.
RETRACT: Then disconnect power trom the No. 2
terminal.
4 .
l _ 1 *
ilT fl
I r t r I
5.
lf the motor fails to operate properly. replace it.
ANTENNA MAST
Sticking Ant€nna:
The antenna sticks in either the up or down position.
1. Using the antanna nut wrench. remove the special
nut, spacer, and bushing (see next pagel,
2.
Clean the antenna mast housing threads, then
reinstall the spacer and bushing.
PLASTIC SLEEVE
ANTENNA MAST
Use the antenna nut wrench and torque the special
nut to 2.3 N.m (0.23 kg-m. 1 .7 lb-tt). lf the special
nut is over-torqued, the antenna may stick. It stick-
ing occurs. back the nut off until the antenna
moves freelv.
23-213
5 .