Honda Prelude 1993 Service Manual page 1282

Dash Lights Brightness Control
CAUTION:
a All SRS electrical wiriog harness€s are cov€r€d with
yellow out€l insulation.
o Befora disconnecting tho SRS wire harness. install
the short connector{s) on the airbag(s) (see page
23-294t.
a R€place th€ entire aflectod SRS hahoss assombly if
it has an open circuit or damagod wiring.
a After installing tho gauge assembly, rocheck th6
opo.ation ot th€ SRS indicator light.
Control Unit Input Test
1 . R e m o v e t h e s u b
2 3 - 1 3 1 ) .
2. Disconnect the 6-P
unit.
gauge assembly {see page
connector trom the control
3.
Inspect the connector terminals to be sure they are
all making good contact.
a lf the terminals are bent, loose. or corroded,
repair them as necessary. and recheck the
svstem.
a l{ the t€rminals look OK. make the following in-
Dut tests at the connector.
- It a test indicates a problem, find and correct
the cause, then recheck the system.
- lf all input tests prove OK, the control unit
must be faulty; replace it
RED/BLU
23-204