Honda Prelude 1993 Service Manual page 1166

Overrunning Clutch Check
1 . Check that the overrunning clutch moves along the
shaft frsely. lf not, replace it.
Check that the overrunning clutch locks in one direc-
tion and rotates smoothly in reverse. lf it does not
lock in either direction or it locks in both directions,
reDlace it.
Check the starter driv€ gear for wear and damage.
lf the gear is worn or damaged, replace the overrun-
ning clutch assembly; the gear is not available
separately.
NOTE: Check the condition ot the flywheel or tot-
que conv€rter ring gear if the starter drive gear teeth
are damaged.
trI
Startel Reassembly
Reassemble the starter in the reverse order of
disassembly.
l.
Pry back each brush spring with a screwdriver,
then position the brush about haltway out of its
holder, and release the spring to hold it there.
2. Install the armature in the housing. Next pry back
each brush spring again and push the brush down
until it seats against the commutator, then release
the spring against the end ot the brush.
aw
3.
Install the end cover on the brush holder.
BRUSH HOLDER
23-87