Honda Prelude 1993 Service Manual page 1227

Replacement
A/T Gear Position Switch
Fre€ play
-
]tl
@t
ll\''--
q---------.__-
LOCK PIN
1
5 -
6 .
Adiustment
Shift to the lll position and loosen the switch nuts.
Slide the switch rearward lup to 2.0 mm (0.O8 in)l
until there is continuity between No. 8 and No. 11
terminals within the range of free play of the shift
lever.
3,
Recheck for continuity between each of the
termtnals.
N O T E :
a li adiustment is not possible, check ior damage
to the shift lever detent and/or bracket,
lf there is no damage, replace the A/T gear posi-
tion switch.
a The engine should start when the shift lever is in
position @ anywhere within the range of free
p l a y .
Adjust rearward
lup to 2.0 mm (O.O8 in)l
A/T Gear Position Switch
Remove the console, then disconnect the 12-P and
3-P connectors trom the switch.
Remove the two mounting nuts and remove the
switch.
SHIFT LEVER
GEAR POSITION
swtTcH
Position the slider on the new switch to positionE
as shown above.
Shift the lever to
"Neutral". then slip the switch in-
to position,
Attach the switch with the two mounting nuts.
Test the switch in the @ and $
positions.
NOTE: The engine should start when the shift
lever is in position fl anywhere in the range of free
ptay.
Connect the 12-P and 3-P connectors, clamp the
harness. and install the console.
SWITCH SLIDER lln po3ition LLI)
23-149