Show Lldp Neighbors - Dell Z9500 Command Reference Manual

To return to the global LLDP configuration mode, use the no protocol lldp
command from Interface mode.
Defaults LLDP is not enabled on the interface.
Command INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
Usage
Before LLDP can be configured on an interface, it must be enabled globally from
Information
CONFIGURATION mode. This command places you in LLDP mode on the
interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the no protocol lldp from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.

show lldp neighbors

Display LLDP neighbor information for all interfaces or a specified interface.
Z9500
Syntax
show lldp neighbors [interface] [detail]
Parameters
interface
1186
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Link Layer Discovery Protocol (LLDP)