Command
INTERFACE VLAN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage
When you use the no tagged command, the interface is automatically placed in
Information
the Default VLAN as an untagged interface unless the interface is a member of
another VLAN. If the interface belongs to several VLANs, remove it from all VLANs
to change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can
only belong to one VLAN at a time.
Related
interface vlan
Commands
untagged
track ip
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.
Z9500
Syntax
track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface
command.
Parameters
interface
Layer 2
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures a VLAN.
— specifies which interfaces in a VLAN are untagged.
Enter the following keywords and slot/port or number
information:
•
For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
1161