Dell Z9500 Command Reference Manual page 1215

Hide thumbs Also See for Z9500:

Table of Contents

The S-Series default is 4000.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

This feature allows you to limit the number of multicast entries on the system. This

number is the total of all the multicast entries on all line cards in the system. On

each line card, the multicast module only installs the maximum number of entries,

depending on the configured CAM profile.

To store multicast routes, use the IN-L3-McastFib CAM partition. It is a separate

hardware limit that exists per port-pipe. This hardware space limitation can

supersede any software-configured limit. The opposite is also true, the CAM

partition might not be exhausted at the time the system-wide route limit set by the

ip multicast-limit command is reached.

show ip igmp groups

Enter the desired maximum number of multicast entries on

the system. The S-Series range is from 1 to 16000.

Added support for VRF. Introduced on the S6000-ON.

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the C-Series.

Introduced on the E-Series.

— shows the IGMP groups.