Advertisement
Chapter 5
Troubleshooting
Note
The following steps reset all configuration settings to factory defaults, including passwords, WEP keys,
the IP address, and the SSID.
Using the MODE Button
Follow these steps to delete the current configuration and return all bridge settings to factory defaults
using the MODE button:
Disconnect the power jack on the power injector.
Step 1
Press and hold the MODE button while you reconnect power to the power injector.
Step 2
Hold the MODE button until the Status LED turns amber (approximately 3 seconds), and release the
Step 3
button.
After the bridge reboots, you must reconfigure the bridge by using the Web browser interface, the
Step 4
Telnet interface, or IOS commands.
Note
Using the Web Browser Interface
Follow the steps below to delete the current configuration and return all bridge settings to the factory
defaults using the web browser interface.
Step 1
Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later) or Netscape
Navigator (version 4.x).
Step 2
Enter the bridge's IP address in the browser address line and press Enter. An Enter Network Password
screen appears.
Step 3
Enter your username in the User Name field.
Step 4
Enter the bridge password in the Password field and press Enter. The Summary Status page appears.
Step 5
Click System Software and the System Software screen appears.
Click System Configuration and the System Configuration screen appears.
Step 6
Click the Default button.
Step 7
Note
After the bridge reboots, you must reconfigure the bridge by using the Web browser interface, the Telnet
Step 8
interface, or IOS commands.
OL-4072-01
D R A F T - C I S C O C O N F I D E N T I A L
The bridge is configured with the factory default values including the IP address (set to receive
an IP address using DHCP). To obtain the bridge's new IP address, refer to the
Setup Utility" section on page
If the bridge is configured with a static IP address, the IP address does not change.
4-9.
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
Resetting to the Default Configuration
"Using the IP
5-9
Advertisement
Chapters
