Door Latch Replacement - Honda Civic Service Manual

7. Pull out the outer handle (A), then remove it.
Installthe handle in the reverse order of removal,
and note these items:
. Make sure each rod is connected securelv.
. Make sure the door locks and opens properly.
. W h e n i n s t a l l i n g t h e l o c k c y l i n d e r . l e a v e t h e o u t e r
door handle bolts loose so the inner protector
does not interfere with the lock cylinder
installation, then tighten the handle bolts.
. Install the lock cylinder retaining clip on the
handle, then install the lock cylinder. Be sure the
c l i p i s f u l l y s e a t e d i n t h e s l o t o n t h e l o c k c y l i n d e r .
. W h e n r e i n s t a l l i n g t h e d o o r p a n e l , m a k e s u r e t h e
plastic cover is installed properly, and is sealed
around the covers Derimeter.
Door Latch Replacement
NOTE: Put on gloves to protect your hands.
1. Remove these items:
3 .
4 .
. Door panel (see page 20-4)
. Plastic cover, as necessary (see page 20-2)
Raise the glass fully.
Remove the lock rod protector (see step 3 on page
20-6).
Pullthe glass run channel (A) away as necessary,
and remove the bolt, then remove the center lower
channel (B) by pulling il downward
Fastenor Location
> : Bolt, 1
IIilE
q
6 x 1 . 0 m m
8 N.m
{0.8 kgf.m, 6 lbf.ftl
(cont'd)
20-7