Polycom RMX 1500 Administrator's Manual page 344

Polycom RMX 1500/2000/4000 Administrator's Guide
10 If required, click the QoS tab.
14-16
Table 14-7 Default IP Service – Conferencing – Ports Parameters (Continued)
Field
UDP Port from - to
If the network administrator does not specify an adequate port range, the system will accept the
settings and issue a warning. Calls will be rejected when the MCU's ports are exceeded.
Quality of Service (QoS) is important when transmitting high bandwidth audio and
video information. QoS can be measured and guaranteed in terms of:
• Average delay between packets
• Variation in delay (jitter)
• Transmission error rate
DiffServ and Precedence are the two QoS methods supported by the RMX. These
methods differ in the way the packet's priority is encoded in the packet header.
Description
Displays the default settings for port numbers used for audio and
video.
To modify the number of UDP ports:
•
In MPM Card Configuration Mode:
Enter the first and last port numbers in the range.
The number of ports is calculated as follows:
Number of simultaneous calls x 8 ports (2 audio, 2 video, 2
Content and 2 FECC).
• In MPM+/MPMx Card Configuration Mode:
Enter the first and last port numbers in the range, and the range
must be 1024 ports.
When ICE environment is enabled, the range must be 2048 ports.
Polycom, Inc.