Polycom RMX 1500 Administrator's Manual page 233

3
Polycom, Inc.
Define the Profile name and, if required, the Profile general parameters:
Table 8-1 New Profile - General Parameters
Field/Option
Display Name
Routing Name
Line Rate
High Definition Video
Switching
Description
Enter a unique Profile name, as follows:
•
English text uses ASCII encoding and can contain the most
characters (length varies according to the field).
• European and Latin text length is approximately half the length of
the maximum.
• Asian text length is approximately one third of the length of the
maximum.
It is recommended to use a name that indicates the Profile type, such
as Operator conference or Video Switching conference.
Note: This is the only parameter that must be defined when creating
a new profile.
Enter the Profile name using ASCII characters set.
The Routing Name can be defined by the user or automatically
generated by the system if no Routing Name is entered as follows:
• If an all ASCII text is entered in Display Name, it is used also as
the Routing Name.
• If any combination of Unicode and ASCII text (or full Unicode text)
is entered in Display Name, the ID (such as Conference ID) is
used as the Routing Name.
Select the conference bit rate. The line rate represents the combined
video, audio and Content rate.
The default setting is 384 Kbps.
If the Operator Conference option is selected, this option is disabled,
and the selection is cleared.
When selected, the conference is ultra-high quality video resolution,
in a special conferencing mode which implies that all participants
must connect at the same line rate and use HD video.
This feature utilizes the resources more wisely and efficiently by:
• Saving utilization of video ports (1 port per participant as opposed
to 4 ports in CP mode).
• Video display is in full screen mode only and video is switched to
the speaker.
Drawbacks of this feature are that all participants must connect at the
same line rate, (e.g. HD) and all participants with endpoints not
supporting HD will connect as secondary (audio only).
Select the High Definition resolution; select either HD 720p or
HD 1080p (in MPM+ and MPMx mode only).
If HD 1080p is selected, endpoints that do not support HD 1080p
resolution are connected as Secondary (Audio Only) participants.
Notes:
• High Definition Video Switching conferencing mode is unavailable
to ISDN participants.
For more information, see "Video Resolutions in CP" on page 2-3.
Chapter 8-Operator Assistance & Participant Move
8-7