Polycom RMX 1500 Administrator's Manual page 681

Table C-18 Event Fields for Events 17, 23 - H323 PARTICIPANT CONNECTED, SIP PARTICIPANT
Field
Secondary Cause
Table C-19 Event Fields for Event 18 - NEW UNDEFINED PARTICIPANT
Field
Participant Name
Participant ID
Dialing Direction
Bonding Mode
Number of
Channels
Net Channel Width
Network Service
Name
Polycom, Inc.
CONNECTED (Continued)
Description
Note: This field is only relevant if the Participant Status is Secondary.
The cause for the secondary connection (not being able to connect the video
channels), as follows:
0 - Default.
11 - The incoming video parameters are not compatible with the conference
video parameters
13 - The conference video settings are not compatible with the endpoint
capabilities
14 - The new conference settings are not compatible with the endpoint
capabilities
15 - Video stream violation due to incompatible annexes or other
discrepancy
16 - Inadequate video resources
17 - When moved to a Transcoding or Video Switching conference, the
participant's video capabilities are not supported by the video cards
18 - Video connection could not be established
24 - The endpoint closed its video channels
25 - The participant video settings are not compatible with the conference
protocol
26 - The endpoint could not re-open the video channel after the conference
video mode was changed
27 - The gatekeeper approved a lower bandwidth than requested
28 - Video connection for the SIP participant is temporarily unavailable
255 - Other
Description
The name of the participant.
The identification number assigned to the participant by the MCU.
The dialing direction, as follows
0 - Dial-out
5 - Dial-in
Not supported.
Always contains the value 0.
Note: This field is only relevant to ISDN/PSTN participants.
The number of channels being connected for this participant.
Not supported.
Always contains the value 0.
The name of the Network Service.
An empty field "" indicates the default Network Service.
Appendix C-CDR Fields - Unformatted File
C-25