Polycom RMX 1500 Administrator's Manual page 341

6
7
Polycom, Inc.
Click the Gatekeeper tab.
Modify the following fields:
Table 14-6 Default IP Service – Conferencing – Gatekeeper Parameters
Field
Gatekeeper
Primary Gatekeeper
IP Address or Name
Alternate Gatekeeper
IP Address or Name
MCU Prefix in
Gatekeeper
Register as Gateway
Description
Select Specify to enable configuration of the gatekeeper IP address.
When Off is selected, all gatekeeper options are disabled.
Enter either the gatekeeper's host name as
registered in the DNS or IP address.
Enter the DNS host name or IP address of the
gatekeeper used as a fallback gatekeeper used
when the primary gatekeeper is not functioning
properly.
Enter the number with which this Network Service registers in the
gatekeeper. This number is used by H.323 endpoints as the first part
of their dial-in string when dialing the MCU.
When PathNavigator or SE200 is used, this prefix automatically
registers with the gatekeeper. When another gatekeeper is used, this
prefix must also be defined in the gatekeeper.
Select this check box if the RMX unit is to be seen as a gateway, for
example, when using a Cisco gatekeeper.
Note: Do not select this check box when using Polycom
ReadiManager/CMA 5000 or a Radvision gatekeeper.
Chapter 14-Network Services
Note: When in
IPv4&IPv6 or
in IPv6 mode, it
is easier to use
Names instead
of IP
Addresses.
14-13