Room (Participant/Endpoint) Level; Automatic Detection Of Immersive Telepresence (Itp) Sites - Polycom RMX 1500 Administrator's Manual

Polycom RMX 1500/2000/4000 Administrator's Guide
•
•
•

Room (Participant/Endpoint) Level

•
•
•

Automatic detection of Immersive Telepresence (ITP) Sites

When the conference Telepresence Mode is set to Auto (Default) ITP endpoints are
automatically detected.
If an ITP endpoint is detected in such conference, ITP features are applied to all endpoints
and the RMX sends conference video with the following options disabled:
•
•
•
•
•
•
•
•
The ITP features are dynamic, and if all ITP endpoints disconnect from the conference,
normal conference video is resumed for the remaining all participants. ITP features are re-
applied to all participants should an ITP endpoint re-connects to that conference.
2-66
— same layout
— presentation mode
— auto layout
— lecture mode
The master (center) camera is used for video, audio and content.
Conference Templates can be used to simplify the setting up Telepresence conferences
where precise participant layout and video forcing settings are crucial. Conference
Templates:
— Save the conference Profile.
— Save all participant parameters including their Personal Layout and Video Forcing
settings.
An ongoing Telepresence conference can be saved to a Conference Template for later re-
use.
For more information see "Conference Templates" on page 9-1.
To the RMX, each camera in a Telepresence room is considered to be an endpoint and is
configured as a participant.
The Telepresence Mode field is always displayed in the New Participant dialog box. If the
system is not licensed for Telepresence this field is automatically set to None.
Telepresence participants (endpoints) must be specified as:
— RPX – transmitting 4:3 video
or
— TPX – transmitting 16:9 video
Borders
Site names
Speaker indication
Skins
Same Layout
Presentation Mode
Auto Layout
Lecture Mode
Polycom, Inc.