Polycom RMX 1500 Administrator's Manual page 507

3
4
5
6
7
8
For flag changes to take effect, reset the MCU. For more information see "Resetting the RMX" on
page 19-104.
Polycom, Inc.
In the CS_MODULE_PARAMETERS tab, the following flags can be added or modified:
Table 19-3 System Flags – CS_MODULE_PARAMETERS
Flag
H323_RAS_IPV6
MS_UPDATE_CONTACT_RE
MOVE
QOS_IP_SIGNALING
To modify a flag value, double-click or select the flag and click the Edit Flag button.
In the New Value field, enter the flag's new value.
Click OK to close the Update Flag dialog box.
Repeat steps 2–4 to modify additional flags.
Click OK to close the System Flags dialog box
Description
If the RMX is configured for IPv4 & IPv6 addressing, RAS
(Registration, Admission, and Status) messages are sent in
both IPv4 and IPv6 format. If the gatekeeper cannot operate
in IPv6 addressing mode, registration fails and endpoints
cannot connect using the RMX prefix.
In such cases this System Flag should be set to NO.
Default: YES
When the flag value is set to:
•
YES - The Contact Header is removed from the UPDATE
message that is sent periodically to the endpoints.
This is required when the SIP Server Type field of the IP
Network Service is set as Microsoft. Removal of the
Contact Header from the UPDATE message is required
specifically by OCS R2.
•
NO - The Contact Header is included in the UPDATE
message. This is the system behavior when the SIP
Server Type is set as Generic.
This is required when the RMX is configured to accept
calls from both Microsoft LYNC and Cisco CUCM as
CUCM requires the Contact Header.
Used to select the priority of IP packets when DiffServ is the
is the selected method for packet priority encoding.
Range: 0x##
Default: 0x00
Chapter 19-RMX Administration and Utilities
19-15