Polycom RMX 1500 Administrator's Manual page 653

Table B-1 Alarms (Continued)
Alarm Code
Low Processing Memory
Low system Memory
Management Network not configured
MCU is not configured for AVF
gatekeeper mode
MCU reset
MCU Reset to enable Diagnostics mode
Missing Central Signaling configuration
MPL startup failure. Authentication not
received.
MPL startup failure. Management
Network configuration not received.
Music file error
No clock source
No default ISDN/PSTN Network Service
defined in ISDN/PSTN Network Services
list
No default IVR Service in IVR Services
list
No IP Network Services defined
No ISDN/PSTN Network Services defined
No License for ISDN/PSTN. Please
activate the RTM ISDN card through
Polycom website
No response from Central Signaling
No response from RTM ISDN card
No usable unit for audio controller;
NTP synchronization failure
Polycom default User exists. For security
reasons, it is recommended to delete this
User and create your own User.
Polycom, Inc.
Alarm Description
Low Processing Memory:
Process is approaching memory utilization limit: [Memory Utilization Percent]
Low system Memory:
The system exceeded 80% of memory usage.
The MCU was reset automatically or by the user.
MCU reset:
Reset cause: [reset source].
The music file played during the connection to the conference cannot be
accessed.
The system could not use any of the connected ISDN spans as clock source
No default IVR Service in IVR Services list: Ensure that one conference IVR
Service and one EQ IVR Service are set as default.
IP Network Service parameters missing.
No ISDN/PSTN Network Services were defined or no default ISDN/PSTN
Network was defined.
No connection with central signaling.
The system failed to synchronize the MCU clock with the NTP clock
Appendix B-Alarms and Faults
B-7