Polycom RMX 1500 Administrator's Manual page 656

Polycom RMX 1500/2000/4000 Administrator's Guide
Table B-1 Alarms (Continued)
Alarm Code
SSH is enabled
Startup process failure
SWITCH not responding
System Configuration modified
Task terminated
Temperature Level - Critical
Temperature Level - Major
Terminal initiated MCU reset
The Log file system is disabled
The software contains patch(es)
The system has been configured for Ultra
Secure Mode, but communication is not
secured until a TLS certificate is installed
and the MCU is set to Secured
Communication.
Unit not responding
Unspecified problem
User initiated MCU reset
User Name "SUPPORT" cannot be used
in Ultra Secure Mode
Version upgrade is in progress
Voltage problem
Yellow Alarm
B-10
Alarm Description
Process failed:
[Process name] failed to start.
System configuration flags were modified.
Reset the MCU.
Task terminated: [Task Name].
Possible explanations:
• Temperature has reached a critical level. Card or if critical system element
the MCU will shut down.
Possible explanations:
•
Temperature has reached a problematic level and requires attention.
MCU reset was initiated by Terminal command [reset].
Log file system error:
The Log File System is disabled. Log files not found.
The software contains patch(es).
Although the System Flag ULTRA_SECURE_MODE is set to YES, the Ultra
Secure Mode is not fully implemented as the TLS certificate was not installed.
Please install the TLS certificate and set the MCU to Secured Communication
Mode to fully enable the Enhanced Security Environment.
Possible explanations:
• Unspecified card error.
• Unspecified shelf error.
•
Unspecified problem.
MCU reset was initiated by a system user.
When Ultra Secure Mode (ULTRA_SECURE_MODE=YES) is enabled, the
User Name "SUPPORT" cannot be used to define a new User.
Possible reasons for the problem:
•
Card voltage problem.
• Shelf voltage problem.
• Voltage problem
Polycom, Inc.