Polycom RMX 1500 Administrator's Manual page 652

Polycom RMX 1500/2000/4000 Administrator's Guide
Table B-1 Alarms (Continued)
Alarm Code
Incorrect Ethernet Settings
Insufficient resources
Insufficient UDP Ports
Internal MCU reset
Internal System configuration during
startup
Invalid date and time
Invalid MCU Version
Invalid System Configuration
IP addresses of Signaling Host and
Control Unit are the same
IP Network Service configuration modified
IP Network Service deleted
IP Network Service not found
ISDN/PSTN Network Services
configuration changed
License not found
B-6
Alarm Description
Incorrect Ethernet Settings:
Ethernet should be set to 100 Full Duplex, Auto Negotiation - off.
Insufficient resources.
Possible explanations:
• McmsDaemon reset due to policy decision: [Process failed [abs crash
counter: crash counter]: process name].
• McmsDaemon reset due to policy decision: [Process failed [abs crash
counter: crash counter]: process name]; Cannot reset while system is in
DEBUG mode.
• Power down signal was detected.
•
[CS Component Failure; unit type:
[NonComponent\CSMngnt\CSH323\CSSIP]\CS Component Failure; unit
type: (invalid: [unit type])\No connection with CS]; Cannot reset while
system is in DEBUG mode.
•
Reset cause unknown: [reset source]\Restore Factory Defaults - [mcu
restore name]\CM_Loaded indication repeated; boardId: [boardId]\reset
from Cards process - simulation\No connection with MPM; board
Id:[boardId]\SmMfaFailure - boardId: [boardId]. Status: [status], problem
bitmask: [problemBitMask]\MPM failure, boardId: [slotId]\Switch failure\No
connection with Switch.
System configuration during startup.
Invalid date and time:
MCU year ([year]) must be 2000 or later.
MCU Version: [Major.Minor.release.internal].
IP Network Service was modified.
Reset the MCU.
IP Network Service was deleted.
Reset the MCU.
Possible explanations:
•
IP Service not found in the Network Services list.
•
m_StatusRead IpServiceList.
Polycom, Inc.