Polycom RMX 1500 Administrator's Manual page 514

Polycom RMX 1500/2000/4000 Administrator's Guide
19-22
Table 19-4 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag and Value
IVR_MESSAGE_VOLUME
IVR_ROLL_CALL_VOLUME
IVR_ROLL_CALL_USE_TON
ES_INSTEAD_OF_VOICE
MINIMUM_FRAME_RATE_T
HRESHOLD_FOR_SD
MIX_LINK_ENVIRONMENT
NUMBER_OF_REDIAL
PARTY_GATHERING_DURA
TION_SECONDS
PCM_FECC
Description
The volume of IVR messages varies according to the value of
this flag.
Possible value range: 0-10 (Default: 6).
0 – disables playing the IVR messages
1 – lowest volume
10 – highest volume
Note: It is not recommended to disable IVR messages by setting
the flag value to 0.
The volume of the Roll Call varies according to the value of
this flag.
Possible value range: 0-10 (Default: 6).
0 – disables playing the Roll Call
1 – lowest volume
10 – highest volume
Note: It is not recommended to disable the Roll Call by setting
the flag value to 0.
This flag was replaced by a selectable option in the
Conference IVR Service - Roll Call/Notifications tab.
Low quality, low frame rate video is prevented from being sent
to endpoints by ensuring that an SD channel is not opened at
frame rates below the specified value.
Range: 0 -30
Default: 15
In H.239-enabled MIH Cascading, when MGC is on level 1,
setting this flag to YES will adjust the line rate of HD Video
Switching conferences run on the RMX 1500/2000/4000 from
1920Kbps to 17897, 100bits/sec to match the actual rate of
the HD Video Switching conference running on the MGC.
Note: If the flag MIX_LINK_ENVIRONMENT is set to YES,
the IP_ENVIRONMENT_LINK flag must be set to NO.
Enter the number re dialing attempts required. Dialing may
continue until the conference is terminated.
Default: 3
The value of this System Flag sets the duration, in seconds, of
the display of the Gathering slide for participants that connect
to the conference after the conference start time.
Range: 0 - 3600
Default: 15
For more information see "Video Preview" on page 2-37.
Determines whether the DTMF Code, ##, the Far/Arrow Keys
(FECC) or both will activate the PCM interface. This flag can
be also be used in combination with DTMF code definitions to
disable PCM.
Possible Values: YES / NO
Default: YES.
Polycom, Inc.