Gather Network Equipment And Address Information - Ip Network Services Required Information - Polycom RMX 1500 Administrator's Manual

2
3
4
5
If the RMX 2000 you are upgrading does not include RTM ISDN or RTM LAN cards, you must install
at least one RTM LAN card to enable the definition of multiple Network Services. If no RTM ISDN or
RTM LAN cards are installed, the RMX 2000 works in a single Network Service mode and an alarm
is issued by the system. For more details about the installation of RTM LAN cards, see the RMX
2000 Hardware Guide.
6
7
8
9
Gather Network Equipment and Address Information - IP Network Services
Required Information
It is important that before connecting multiple networks and implementing Multiple
Services in the RMX, that you obtain the information needed to complete the IP Network
Service configuration for each connected network from your network administrator.
Table 14-26
Parameter
Signaling Host IP address
Media Board IP address
(MPM 1)
Media Board IP address
(MPM 2)
RMX 2000/4000 only
Media Board IP address
(MPM 3)
RMX 4000 only
Polycom, Inc.
Upgrade to the new version and install the activation key that contains the Multiple
Services license as described in RMX 1500/2000/4000 Release Notes, "Upgrade Paths to
Version 7.5.0.J" on page 23.
Place several calls and run conferences to ensure that the system upgrade was
completed successfully.
Modify the required System Flag to enable Multiple Services, DO NOT reset the MCU
yet.
Connect the additional network cables to the RMX and change existing connections to
match the required configuration as described in the "RMX Hardware Installation" on
page 50.
At this point, the Management Network can be modified to match the required local
network settings.
Reset the MCU.
Connect to the MCU and Add the required IP Network Services to accommodate the
networks connected to the RMX unit.
Select a Network Service to act as default for dial out and gateway calls for which the
Network Service was not selected.
Place several calls and run conferences to ensure that the system is configured correctly.
Network Equipment and Address Information per IP Network Service
Local Network Settings
Chapter 14-Network Services
Note
If more than one media card is
associated with this Network
Service
If more than one media card is
associated with this Network
Service
14-49