Enable Ip-Subnet-Lookup - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

enable ip-subnet-lookup

enable ip-subnet-lookup
Description
Enables IPDA subnet lookup feature in a switch.
Syntax Description
There are no arguments or variables for this command.
Default
Disabled
Usage Guidelines
For a new setting to be effective in the "i" series switches, system rebooting is needed. Rebooting is not
needed for the "e" series switches.
On the "i" series switches, if IPDA subnet lookup is enabled for the first time, the IPDA subnet lookup
mask length is 24 (255.255.255.0).
Example
enable ip-subnet-lookup
To be effective, system rebooting is needed
# show ipc
IP Routing : Enabled
.....
MPLS : Disabled
IP-SUBNET-Lookup : Run-Time[Disabled:
In default status, IPDA SUBNET lookup feature is disabled.
# show ipc
IP Routing : Enabled
.....
MPLS : Disabled
IP-SUBNET-Lookup : Run-Time[Disabled:
If flow redirections, IPDA QOS, or FDB ACL is configured, operation is aborted with
error message
# enable ip-subnet-lookup
ERROR: Flow Redirection is already configured. Remove flow redirection configuration
at first.
History
This command was first available in ExtremeWare 7.3.0.
This command was added to the "e" series switches in ExtremeWare 7.5.
998
0] Config[Enabled: 24]
0] Config[Disabled: 0]
ExtremeWare 7.5 Command Reference Guide