Configure Wireless Ports Interface Ap-Scan Send-Probe - Extreme Networks ExtremeWare Command Reference Manual

configure wireless ports interface ap-scan send-probe

configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
send-probe [on |
Description
Use this command to enable the sending of probes for active scanning.
Syntax Description
portlist
all
interface
on
off
Default
Off.
Usage Guidelines
Use this command to enable the sending of probes. Setting
Setting
send-probe
Example
The following example enables the port range 1:15-1:24 using interface 1 to enable probes.
configure wireless ports 1:15-1:24 interface 1 ap-scan send-probe on
History
This command was first available in ExtremeWare 6.2a and added to the "i" series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
ExtremeWare Software 7.3.0 Command Reference Guide
off]
Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
Specifies all ports.
Specifies an interface: 1 or 2.
Specifies to send probes (active scanning).
Specifies not to send probes (passive scanning).
to specifies passive scanning.
off
configure wireless ports interface ap-scan send-probe
to specifies active scanning.
send-probe on
2019