Mounting The Drum Motor Assembly - Canon CLC 1120 Service Manual

11) Remove the static eliminator brush.
12) Disconnect the two connectors [12], and
remove the seven screws [13]; then,
detach the drum motor assembly [14]
together with the fixing plate.
13) Remove the four screws, and detach the
drum motor from the mounting plate.
2. Mounting the Drum Motor
Assembly
When the drum motor assembly is
removed from the copier, be sure to adjust its
position using the drum shaft position tool
(FY9-3045-000) when mounting it back to
eliminate any discrepancy.
1) Slide out the photosensitive drum unit
from the copier.
2) Remove the six screws [1], and detach the
photosensitive drum butting block [2]
(front, rear);
photosensitive drum [3] from the
photosensitive drum frame unit [4].
3) Insert the photosensitive drum frame unit
[5] in the copier, and mount it with three
screws [6].
COPYRIGHT © 1999 CANON INC.
CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
then, detach the
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[13] [13] [12]
[13] [13]
Figure 9-730
[4]
[1] [2]
Figure 9-731
[6] [5] [6]
Figure 9-732
[13]
[14]
[2] [1]
[3]
[6]
9-29