CHAPTER 10 PAPER DECK
5) Remove the screw [8] and the stopper
plate [9]; then, slide the compartment [10]
farther to the front.
6) Remove the three screws [12] each from
the left and right of the compartment rails
[11]; then, lift the compartment slightly,
and detach it to the front.
7) Place the compartment on the base
prepared in step 1).
3. Changing the Deck Paper Size
If the deck paper size must be changed to
comply with the user's request, perform the
following:
1) Open the compartment of the deck, and
remove all paper.
2) If the lifter of the deck is up, turn on the
copier, and push the sensor lever [2] of the
paper supply position sensor inside the
compartment [1] so that the lifter will
move down to its lower limit.
10-26
COPYRIGHT © 1999 CANON INC.
[9]
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[10]
[8]
Figure 10-318
[12]
[12]
Figure 10-319
[2]
[1]
Figure 10-320
[11]