Canon CLC 1120 Service Manual page 37

Mode
Timer Auto Clear Time
Settings
Auto Energy Saver Time
Auto Power-Off Time
Adjustment/ Zoom Fine Adjustment
Cleaning
Exposure Recalibration
Auto Gradation
Adjustment
Text/Photo Priority
Printer Gradation
Adjustment
SWOP Emulation
Adjustment
Feeder Cleaning
Wire Cleaning
Original Type
Selection for Printer
* : default.
COPYRIGHT © 1999 CANON INC.
Use it to set the time after which the touch panel
returns to the Standard screen at the end of operation.
(0 to 9 min/2 min*)
Use it to set the time after which energy save mode
starts. (0 min to 8 hr/30 min*)
Use it to set the time after which the power is turned off
when the copier is ready for copying or in energy save
mode. (0 to 24 hr/1 hr*)
Use it to make fine-adjustments if the original size and
the copy size have a slight discrepancy in vertical and
horizontal reproduction ratios.
Range:
Unit:
Use it to correct the density used for the manual density
adjustment standard (center graduation).
Use it to correct the hue of images.
Use it to adjust the slice level used to distinguish
between text and photo when the original type is set to
"text/printed photo" or "text/silver halide photo."
Use it to smooth out the gradations of color for printer
output. (on*/off)
Use it to lower the density of halftone areas to simulate
printed hues.
Use it to clean the feeder by placing copy paper in the
feeder. (The paper will be circulated inside the feeder,
thereby removing dirt from the pickup roller assembly.)
Use it to clean the wires of charging assemblies.
Use it so that the output images from the controller
match the types of originals used.
Table 1-402b
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 1 GENERAL DESCRIPTION
Description
±1.0%
0.1%
1-15