Developing Motor Assembly; Removing The Drum Motor Assembly; Points To Note When Installing The Drum Drive Belt; Removing The Developing Motor Assembly - Canon 1000 Service Manual

2. Removing the Drum Motor
Assembly
1) Remove the two screws each, and remove the
two fly wheels.
2) Disconnect the two connectors [1], and
remove the four screws [2]; then, remove the
drum motor assembly [3].
[1]
Figure 4-205A
3. Points to Note When Installing the
Drum Drive Belt
Install the drum drive belt [2] so that the
markings [1] on the drum drive pulleys are all
in the same direction.
[2]
Figure 4-206A
COPYRIGHT © 2001 CANON INC.
[3]
[2]
[1]
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
B. Developing Motor
Assembly
1. Removing the Developing Motor
Assembly
1) Remove the rear cover 1 and the rear cover 2.
2) Remove the two screws, and remove the fly
wheel (left). (This applies only when removing
the M developing motor assembly.)
3) Remove the two screws [1] each, and
disconnect the two connectors [2] each; then,
remove the developing motor assembly [3].
[1]
[3]
[2]
Figure 4-201B
(Y, M developing motor assemblies)
[3]
[3]
Figure 4-202B
(C, Bk developing motor assemblies)
[3]
[1]
[2]
4-11