Chapter 9
F-9-84
9.8.2.14 Removing the Drum
ITB Motor Mounting Base
Points to Note When Removing the Drum ITB
Motor Mounting
To remove, put your hand into the inside where you
have slid out the manual feed unit; then, while holding
down the swing plate [1] found to the rear of the drum
drive unit, remove from the machine's rear side plate.
The drum drive unit is hooked on the protrusion from
the rear side plate; lift it slightly to detach.
F-9-85
1) Free the DC harness [1] found at the front of the
drum ITB motor base from the cable clamp [2].
9-58
2) Disconnect the 2 connectors [1], and remove the 3
0000-4644
screws [2]; then, detach the drum ITB motor base
[3].
9.8.2.15 Removing the Drum
Drive Unit
1) Disconnect the 6 connectors [1], and remove the 7
screws [2]: then, take out the drum drive unit [3].
F-9-86
F-9-87
0000-8360