Removing The Post-Cleaning; Charging Assembly; Adjusting The Height Of The Charging Wire - Canon CLC 1120 Service Manual

CHAPTER 6 IMAGE FORMATION SYSTEM

5. Removing the Post-Cleaning

Charging Assembly

1) Open the hopper unit fully.
2) Remove the screw [1], and detach the
post-cleaning assembly [2].
6. Adjusting the Height of the
Charging Wire
The height of the charging wire may be
adjusted by turning the screw found at the
back of the charging assembly. A full turn of
the screw shifts the position of the charging
wire by about 0.7 mm.
The height of the charging wire of the
internal static eliminator or the post-cleaning
charging assembly, however, cannot be
adjusted.
6-64
COPYRIGHT © 1999 CANON INC.
Charging
assembly
Primary
charging
assembly
Separa-
tion
charging
assembly
External
charging
eliminator
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
[2]
Figure 6-625
Height of charging
wire (mm)
10.5
17.0
Figure 6-626
Range of
adjustment
4 mm
(approx.)
4 mm
(approx.)
4 mm
(approx.)