VII. INSTALLING THE REMOTE DIAGNOSTIC DEVICE II
Note:
The Remote Diagnostic Device II is not available in certain sales areas.
1. Installing to the Copier
When installing the diagnostic device to
the copier, keep the following in mind:
1. Be sure to comply with the laws and
regulations of the country.
2. Be sure that the copier has been
properly installed.
3. Be sure that the copier's power plug is
disconnected.
4. Be sure to identify the screws by type
(length, diameter) and location.
5. Be sure to prepare setting data on the
computer at the service station.
1) Remove the two screws [2], and detach
the top cover.
COPYRIGHT © 1999 CANON INC.
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
[1]
[2]
Figure 11-701
[2]
11-47