Canon CLC 1120 Service Manual page 512

4) Remove the four screws, and detach the
copier's left lower cover.
5) Open the cable guide, and put the 3-pin
end of the relay harness inside. (If the
guide is difficult to open, use a
screwdriver.)
6) Connect the 2-pin end of the relay harness
to the copier's connector.
Caution:
If you are installing the cassette heater to
the CLC1130, make the following
connections:
· relay harness of the upper cassette
heater with the lower connector on
the copier side
· relay harness of the lower cassette
heater with the upper connector on
the copier side
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
Screws
Figure 11-803
Figure 11-804
Relay harness (2-pin)
Relay harness (2-pin)
Figure 11-805
Cable guide
Relay harness
Connector
Connector
11-57