Duplexing Unit Inlet Motor Mount Assembly; Set-Back Roller Motor Assembly - Canon GP215 Service Manual

4. MECHANICAL SYSTEM
C. Duplexing Unit Inlet Motor
Mount Assembly
1. Removing the Duplexing Inlet
Motor Mount Assembly
1) Disconnect the power plug, and remove the
following:
• Rear cover (4 screws)
• Flywheel (3 screws)
• Connector mount
• DC controller PCB (2 screws, all connec-
tors)
• Composite power supply PCB (2 screws,
all connectors)
2) Remove two screws w, and disconnect the
connector e; then, remove the duplexing unit
inlet motor q.
2
3
Figure 4-313
4–14
COPYRIGHT © 1996 CANON INC.
1
2
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
D. Set-Back Roller Motor
Assembly
1. Removing the Set-Back Roller
Motor Assembly
1) Disconnect the power plug, and remove the
following:
• Rear cover (4 screws)
• Flywheel (3 screws)
• Connector mount
• DC controller PCB (2 screws, all connec-
tors)
• Composite power supply PCB (2 screws,
all connectors)
2) Remove the three screws w, and disconnect
the two connectors e; then, remove the set-
back roller motor assembly q.
2
3
3
Figure 4-314
1 2
2