Canon CLC 1120 Service Manual page 460

CHAPTER 11 INSTALLATION
7) Detach the two pins taped to the skid, and
arrange the slope plates, and secure them in
place with the pins. Be sure that each slope
plate is placed so that the boss at the center
faces down.
8) Slide down the copier from the skid.
(Position one person to support from
below while the other pushes from above.)
9) Open the cardboard box, and take out the
parts and materials.
Take out the M, C, Y, and Bk starter
bottles, and shake them well. Peel off the
seals, and keep them in a place free of dust.
This is to make the starters used to the site
of installation.
Caution:
Check to make sure that all attachments
are available.
11-6
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Slope plates
Figure 11-204