H. Main Motor (M4) Drive
Assembly
1. Removing the Main Motor (M4)
1) Remove the rear over.
2) Remove the flywheel.
3) Open the CPU PCB.
4) Remove the back suction fan [1].
5) Remove the six screws [2], and detach the
drive assembly reinforcing plate [3].
6) While lifting the tension plate [4] by hand,
detach the drive belt 1 [5].
7) Disconnect the two connectors [6], and
remove the five screws [7]; then, detach
the main motor assembly [8] together with
the mounting plate.
8) Remove the clamp of the motor output
shaft, and remove the four screws; then,
detach the main motor from the mounting
plate.
COPYRIGHT © 1999 CANON INC.
CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[2]
[2]
[3]
Figure 9-735
[4]
Figure 9-736
[7]
[8]
[7]
Figure 9-737
[1]
[2]
[5]
[7]
[6]
[7]
9-31