Removing The Scraper Of The Attraction Roller; Removing The Attraction Roller; Assembly - Canon CLC 1120 Service Manual

CHAPTER 7 PICK-UP / FEEDING SYSTEM
2) Remove the two screws [3], and detach
the scraper [4].

5. Removing the Attraction Roller

1) Remove the attraction roller unit.
2) Remove the scraper of the attraction
roller.
3) Remove the resin fixing ring [1] at the
front, and detach the attraction roller [2].
6. Replacing the Attraction Roller Unit
Spring Clutch Assembly
1) Remove the attraction roller unit.
2) Using a hex screw, loosen the hex-hole
screw [1], and remove the spring clutch
assembly [2] from the registration roller
assembly rear.
3) Clean the shaft to which the spring clutch
was mounted.
4) Loosen the hex-hole screw of the new
spring clutch assembly.
5) Mount the new spring clutch assembly to
the shaft.
While doing so, keep the spring clutch
assembly butted against the E-ring side.
When loosening the hex-hole screw, be
sure that the screw and the D-cut of the
shaft are perpendicular.
7-80
COPYRIGHT © 1999 CANON INC.
[1]
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[4]
[3]
Figure 7-817
[1]
[2]
Figure 7-818
[2]
Figure 7-819